Open slide.dwg (from problem 4 in Chapter 24). Zoom in so that the slide fills most of the screen. Enter the PLOT command and choose the Limits option in the Plot area portion of the dialog box. Plot the drawing. Then create two more plots, one with the Extents radio button selected, and one with the Display radio button selected. Compare the drawings.

Problem 4

Create a new drawing from scratch using Quick Setup. Set up the layers shown in Table 24-5. Then create the slide shown in Fig. 24-4 on layer Object. Place the center lines on layer Center, positioning them as shown in the illustration. Change back to the Object layer and create the hole (circle) for the slide so that its center point is at the intersection of the two center lines. To finish the drawing, offset the hole by .2 units to the outside and trim the center lines to the outside circle. Erase the temporary trim circle, and save the drawing as slide.dwg.