Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Other Engineering Expert

problem 1: The steady state operational availability of a complex system is associated to the system MTBF, MTTR, MLDT and MADT as shown below:

Ao = MTBF/(MTBF + MTTR + MLDT  + MADT)

The contractual needs are as shown below:

MTBF = 6 hrs,
MTTR = 1.5 hour,
Ao = 0.95.

describe the process and establish contractual needs for MLDT and MADT. Use sketches and computations to justify your required values.

Other Engineering, Engineering

  • Category:- Other Engineering
  • Reference No.:- M9582

Have any Question? 


Related Questions in Other Engineering

Question 1 the two basic kinds of transistor circuits are

Question 1 The two basic kinds of transistor circuits are amplifying and switching. True False Question 2 The bridge rectifier is similar to a full-wave rectifier because it produces a full-wave output voltage. True Fals ...

Problem 1a router is used to cut locating notches on a

Problem 1 A router is used to cut locating notches on a printer circuit board. The vibration level at the surface of the board as it is cut, is considered to be a major source of dimensional variation (lower the better) ...

1the emf of a generator of 377 ohm internal impedance is a

1. The EMF of a generator of 377 ohm internal impedance is a 2 ps long pulse of 12 volt amplitude. The generator drives a 10km long section of transmission line of 377 ohm characteristic impedance and 3 x 10 8 m/s propag ...

If you obtain advice from others or use information from

If you obtain advice from others, or use information from any source including the web, these must be acknowledged in your report. Two sample MATLAB codes are provided at the end of the assignment to help you with this a ...

A steam from a steame generator at 160 bar 540degc having a

A steam, from a steame generator at 160 bar, 540 ° C having a flow rate of 400 kg/s expands in a high pressure turbine with an isentropic efficiency of 90% to 40 bar. A 16 % of the exhaust steam is used for feedwater hea ...

Life cycle and risk management assignment 3 a

Life Cycle and Risk Management Assignment 3: A workplace-based report This assessment task involves collaborative team arrangement efforts and designed to explore engineering asset management as a system incorporating li ...

History of architecture and urbanismpick five questions

History of Architecture and Urbanism PICK FIVE QUESTIONS TOTAL TO BE ANSWERED: Each answer must be 150 to 400 words. To be typed, not hand­written. Email your final exam to your discussion leader. 1. The concept of "mode ...

I have a project about sound detect i am using chipkit

I have a project about sound detect. I am using (ChipKit Max32) as microcontroller and (Bob_09964) as microphones (3 of them to be used) I want the following things: 1- The software codes of (ChipKit Max32) which uses MP ...

1 for a 77t truck with gross vehicle weight gvw of 136078

1. For a 77t truck with Gross Vehicle Weight (GVW) of 136078 kg with dual rear tyres and a tyre inflation pressure is 120 psi (or 8.43 kg/cm 2 ). Use the equivalent single tyre loading. i. Determine the contact surface a ...

Assignmentwhy program design is importantanswer the

Assignment Why Program Design is Important? Answer the following questions: 1. What is a program design? 2. Why program design is important? 3. What program design tools are available? Discuss in details by studying at l ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro