Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) describe the discrete and continuous random variable.

2) describe the axioms of probability.

3) describe the situation when the process is said to be wide sense stationary.

4) prepare differences between the random variable and the random process.

5)  describe what do you mean by measure of information?

6) Specify what is meant by the term Shannon Hartley theorem.

7) describe what is meant by the code efficiency?

8) describe what do you understand by the uniquely decipherable code?

9) describe what is meant by the term noise temperature?

10) describe the friss formula.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M912729

Have any Question? 


Related Questions in Electrical & Electronics

Consider the simple rc circuit shown in fig p23-3 let r 1

Consider the simple RC circuit shown in Fig. P2.3-3. Let R = 1 kΩ and C = 1 nF. (a) Find the system transfer function. (b) Plot the magnitude and phase responses. (c) Show that a lowpass signal x(t) with bandwidth W « 10 ...

A square block of surface area a on all sides is under pure

A square block of surface area A on all sides is under pure shear deformation due to the uniformly distributed load F on the top surface, as shown in the figure. The deformation of the block is such that the deformed coo ...

1 what is the magnetic flux crossing an infinitesimal

1. What is the magnetic flux crossing an infinitesimal surface oriented parallel to the magnetic flux density vector? 2. For what orientation of the infinitesimal surface relative to the magnetic flux density vector is t ...

A voltage source vt 100 cos2pi50 t v is applied to a

A voltage source v(t) = 100 cos(2π50 t) [V] is applied to a nonlinear load, resulting in non-sinusoidal current: i(t) = 4 + 10 cos(2π50 t +30°) + 20 cos (4π50 t +45°) [A]. Determine: (a) the power absorbed on the load, ( ...

Question 1 match the statements below with the answer that

Question 1: Match the statements below with the answer that best matches. Your choices are: Efficiency Full Load Summation of Losses Differential Power Losses Speed Regulation No-Load Power Regulation The same as the num ...

1 why is it that the distances r1 and r2 in the phase

1. Why is it that the distances r 1 and r 2 in the phase factors in equations (8.47a) and (8.47b) cannot be set equal to r, but the same quantities in the amplitude factors can be set equal to r? 2. What is an array fact ...

An infinite plane sheet lying in the plane carries a

An infinite plane sheet lying in the plane carries a current of nonuniform density Find the magnetic field intensities adjacent to the current sheet and on either side of it at (a) the point (0, 1, 0) and (b) the point ( ...

1 explain how a 1 bit 4-to-1 mux can calculate any binary

1. Explain how a 1 bit 4-to-1 MUX can calculate any binary Boolean function. Because the MUX can calculate the result of any Boolean function, we call the MUX a univeral operation. 2. In Logism implement an 8 bit 4-to-1 ...

A line assumed to be infinitely long and of unknown

A line assumed to be infinitely long and of unknown characteristic impedance is connected to a line of characteristic impedance on which standing wave measurements are made. It is found that the standing wave ratio is 3 ...

1 why is it necessary to have the minus sign associated

1. Why is it necessary to have the minus sign associated with the time rate of increase of magnetic flux on the right side of Faraday's law? 2. What is electromotive force? 3. What are the different ways in which an emf ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro