Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Other Engineering Expert

problem 1)a) Describe in detail the evolution of general purpose computing with VLSI technology.

b) List and describe in detail the characteristics of Reconfigurable device.

problem 2)a) What do you mean by configurable, programmable and fixed function devices? Give appropriate exs.

b) What is partial reconfigurability? Are such devices being used commercially? Give suitable exs.

problem 3)a) describe density and diversity. prepare down mathematical expressions.

b) List various reconfigurable devices developed yet. Brief their characteristics/features.

problem 4) prepare brief notes on the given terms:

a) Interconnects.

b) General purpose computing issues.

c) Crossbars.

d) Area consumption by different architectural building blocks in reconfigurable device.

problem 5) describe empirical view of general purpose computing architectures in the age of MOS VLSI. Compare their performances.

problem 6) describe the architectural building blocks of iDPGA and DPGA. prepare down the difference between them?

problem 7)a) What are the problems with simple networks? Suggest best option for reconfigurable device.

b) Provide the mathematical model for Rent’s rule based channel and wire growth.

problem 8) prepare brief notes on:

a) Instruction compression.

b) Resources in reconfigurable devices.

c) Contexts.

d) MATRIX

Other Engineering, Engineering

  • Category:- Other Engineering
  • Reference No.:- M95725

Have any Question? 


Related Questions in Other Engineering

1given the following transfer function modelsy1su1s g11s

1. Given the following transfer function models: y 1 (s)/u 1 (s) = g 11 (s) = 2/(s+3) y 1 (s)/u 2 (s) = g 12 (s) = -1/(s+1) y 2 (s)/u 1 (s) = g 21 (s) = -1/(s+7) y 2 (s)/u 2 (s) = g 22 (s) = 0.5/(s+4) a) Draw the 2x2 ope ...

Assignmentpart 1bullop-amp introduction1read chapters 1-2

Assignment Part 1 • Op-Amp Introduction 1. Read Chapters 1-2 in the text Op Amps for Everyone Fourth Edition 2. For the configuration below: 3. o With Vin = 4Vrms, f = 1kHz answer the following for each case: o Calculate ...

1the emf of a generator of 377 ohm internal impedance is a

1. The EMF of a generator of 377 ohm internal impedance is a 2 ps long pulse of 12 volt amplitude. The generator drives a 10km long section of transmission line of 377 ohm characteristic impedance and 3 x 10 8 m/s propag ...

Short answers of 150-400 words1 engineering and

Short answers of 150-400 words 1. Engineering and architecture are two fields of knowledge that continually intersect and bifurcate in the period that we have been studying. What is relationship between architecture and ...

Homework consider a renewal process let x be the

Homework Consider a renewal process. Let X be the interrenewal times; and let I and R be the length of an interval interrupted at random and its remainder, respectively. The following BASIC simulation calculates the aver ...

Risk factors and gantt chartsquestion 1 project risk

Risk Factors and Gantt Charts Question 1: Project Risk factors • List the major risk factors for your project and the possible ways to mitigate this risks for your project. Question 2: Resource Evaluation • Produce and c ...

1 represent the following decimal numbers in both binary

1. Represent the following decimal numbers in both binary sign/magnitude and two's complement using 16 bits: -29. 2. A Computer uses IEEE-754 format to represent floating points. What value (in decimal) the computer repr ...

Q1 a hollow circular mild steel column of external diameter

Q1. A hollow circular mild steel column of external diameter 300 mm and internal diameter of 250 mm carries an axial load of 1500 kN. a) Determine the compressive stress in the column. b) If the initial length of the col ...

Power flow project -figure 1 shows a single-line diagram of

Power Flow Project - Figure 1 shows a single-line diagram of a five-bus power system. Input data are given in Tables 1, 2, and 3. As shown in Table 1, bus 1 is the swing bus, to which a generator is connected. Bus 3 is a ...

Lab ac modelsintroductionthe lab is based on the ac models

Lab: AC Models Introduction: The lab is based on the AC models of a transistors. After the transistor has been biased with a Q-point near the middle of the load line, we can couple a small AC voltage into the base. This ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen