Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) prepare down detail note on significance of Spread Spectrum System.

2) Compare process gains available for various techniques including signal rejection and cancellation

3) Describe the overall direct sequence system with waveforms.

4) Draw the three stage liner code generator diagrams and describe briefly.

5) What code sequences could be produced by a [7, 2]s generator?

6) Describe about add-and-divide frequency synthesizer. Draw a block diagram to produce 8000 frequency separated by 100 Hz spacing.

7) Find out the mean and base frequencies for a direct, 64 frequency add-and-divide synthesizer with o/p at 70MHz and 10KHz o/p spacing.

8) describe phase lock and Cost as receivers for subcarrier FM or FSK demodulation.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M910628

Have any Question? 


Related Questions in Electrical & Electronics

The device in the schematic diagram below is a viscosity

The device in the schematic diagram below is a viscosity pump. It consists of a rotating drum inside of a stationary case. The case and the drum are concentric. Fluid enters at A, flows through the annulus between the ca ...

1 define the radiation resistance of an antenna2 why is the

1. Define the radiation resistance of an antenna. 2. Why is the expression for the radiation resistance of a Hertzian dipole not valid for a linear antenna of any length? 3. Explain why power lines are not effective radi ...

Clculate the surface integral of the vector function f

Calculate the surface integral of the vector function, F = xe 1  + ye 2 , over the portion of the surface of the unit sphere, S : x 2  + y 2  + z 2  = 1, above the xy-plane, i.e., z > 0.

1 discuss the duality between the radiation fields of a

1. Discuss the duality between the radiation fields of a small circular loop antenna with those of a Hertzian dipole at the center of the loop and aligned with its axis. 2. Compare the radiation resistance and directivit ...

1 for the force field f x2ay find the approximate value of

1. For the force field F = x 2 ay, find the approximate value of the line integral of F from the origin to the point (1, 3, 0) along a straight line path by dividing the path into ten equal segments. 2. For the force fie ...

1 in kademlia assume m 4 and active nodes are n4 n7 and

1. In Kademlia, assume m = 4 and active nodes are N4, N7, and N12. Where is the key k3 stored in this system? 2. In Chord, assume the size of the identifier space is 16. The active nodes are N3, N6, N8, and N12. Show the ...

1 in logisim implement an 8-to-1 mux using 2 4-to-1 muxes

1. In Logisim implement an 8-to-1 MUX using 2 4-to-1 MUXes and a 2-to-1 MUX. 2. In Logisim implement an 8-to-1 MUX using 4 2-to-1 MUXes and a 4-to-1 MUX. 3. In Logisim implement a circuit similar to the one in figure 8-1 ...

1 in one-dimensional dct if n 1 the matrix transformation

1. In one-dimensional DCT, if N = 1, the matrix transformation is changed to simple multiplication. In other words, M = T × p, in which T, p, and M are numbers (scalar value) instead of matrices. What is the value of T i ...

Consider the problem of identifying the nonlinear

Consider the problem of identifying the nonlinear discrete-time system in (9.9.4) using a raised-cosine RBF network. Let the number of past inputs be m = 1 and the number of past outputs be n = 1. Suppose the range of va ...

1 what is a uniform plane wave2 why is the study of uniform

1. What is a uniform plane wave? 2. Why is the study of uniform plane waves important? 3. How is the surface current density vector defined? Distinguish it from the volume current density vector. 4. How do you find the c ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen