+1-415-315-9853

info@mywordsolution.com

## Engineering

 Civil Engineering Chemical Engineering Electrical & Electronics Mechanical Engineering Computer Engineering Engineering Mathematics MATLAB Other Engineering Digital Electronics Biochemical & Biotechnology

problem 1: find out the fugacity of liquid acetone at 110 0C and 275 bar. At 110 0C the vapor pressure of acetone is 4.360 bar and the molar volume of saturated liquid acetone is 73 cm3/mole. For the vapor phase holds: PV/(RT) = 1 + BP/(RT), with B= -700 cm3/mole. R = 8.3144 J/(K.mole) = 83.144 bar/(K.mole).

problem 2: For the binary system 2, 4-dimethylpentane (1) + benzene (2) the excess Gibbs energy of the liquid phase is given by:

GE/(x1x2) = (A12x1 + A21x2)

a) find out the constants A12 and A21 if γ1 = 1.958 and γ2 = 1.478

b) find out at 60°C the pressure and composition of the vapor phase which is in equilibrium with a liquid phase with composition x1 = 0.5. At this temperature the saturated vapor pressures of component 1 and 2 are respectively 52.4 and 52.3 kPa. The vapor phase is ideal and the Poynting correction can be ignored.

c) find out Henry’s constant of component 2 in pure component 1 and of component 1 in pure component 2.

Chemical Engineering, Engineering

• Category:- Chemical Engineering
• Reference No.:- M92005

Have any Question?

## Related Questions in Chemical Engineering

### A potential flow source having an intensity of 10m2s placed

A potential flow source having an intensity of 10m2/s, placed in the point of Cartesian coordinates (1;0), and a sink having identical intensity, placed in the point (-1;0), are combined with a uniform flow at 25 m/s, in ...

### A wing generates a lift l when moving through sea-level air

A wing generates a lift L when moving through sea-level air with a velocity U. How fast must the wing move through the air at an altitude of 35,000 ft if it is to generate the same lift? (Assume the lift coefficient is c ...

### A horizontal 100-mm-diameter pipe passing hot oil is to be

A horizontal 100-mm-diameter pipe passing hot oil is to be used in the design of an industrial water heater. Based on a typical water draw rate, the velocity over the pipe is 0.5 m/s. The hot oil maintains the outer surf ...

### A draw an arbitrary closed contour on figure 711 and show

(a) Draw an arbitrary closed contour on Figure 7.11 and show that it yields zero net flow of current. (b) Suppose a capacitor is inserted into the circuit instead of any of the resistors and the current is switched on. D ...

### Amounts of hardness in mg per l are asmgso4120 cano32164

amounts of hardness (in mg per l) are asmgso4=120 ca(no3)2=164 cacl2=222 mg(hso4)2=73 lime and soda are of 74% and 73% purity respectively. find the amount of lime & soda req. to soften the water

### Two stirred tanks of volume v and 2v are available for

Two stirred tanks of volume "V" and "2V" are available for carrying out a first order irreversible reaction at constant density and temperature. If the flow rate of feed stream is "Q" which of the following arrangement w ...

### A horizontal 25-mm diameter cylinder is maintained at a

A horizontal, 25-mm diameter cylinder is maintained at a uniform surface temperature of 35°C. A fluid with a velocity of 0.05 m/s and temperature of 20°C is in cross flow over the cylinder. Determine whether heat transfe ...

### A well is producing from a saturated oilreservoir with an

A well is producing from a saturated oilreservoir with an average reservoir pressureof 3000 psig. Stabilized flow test dataindicates that the well is capable of producing400 STB/day at a bottom-holeflowing pressure of 25 ...

### 100 moles of a fuel containing methane and butane is burned

100 moles of a fuel containing methane and butane is burned with 25% excess air in a furnace producing stack gas at 300 degrees C and 105 kPa. Determine the amount of 100 psi saturated steam that can be produced from wat ...

### 1 what is the difference between closed and isolated

1) What is the difference between closed and isolated systems? 2) Is it true that thermodynamic equilibrium is reached very rapidly (a few seconds or less) in any system? Justify your answer or provide examples that supp ...

• 4,153,160 Questions Asked
• 13,132 Experts
• 2,558,936 Questions Answered

## Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

### WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

### Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

### Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

### Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

### Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro