Ask Question, Ask an Expert

+61-413 786 465

info@mywordsolution.com

Ask Other Engineering Expert

Bob Byrne's ear was still ringing. Byrne was director of the audit Staff at Zack Electrical Parts. He had just received a phone call from Jim Whitmore, the plant manager. Whitmore was furious. He had just read a report prepared by the Audit Staff concerning cost problems in his Assembly Department.

Whitmore, in a loud voice, said he disagreed with several key sections of the report. He claimed that had he known more about the Audit Staff's work, he could have shown them facts that denied some of their conclusions. He also asked why the report was prepared before he had a chance to comment on it. However, what made him particularly angry was that the report had been distributed to all the top managers at Zack. He felt top management would have a distorted view of his Assembly Department, if not his whole plant.

Byrne ended the call by saying he'd check into the matter. So he called in Kim Brock, one of his subordinates who had headed to audit team for the study in question. Brock admitted that she had not had a chance to talk to Whitmore before completing and distributing the report. Nor had she really had a chance to spend much time with Dave Wells who headed the Assembly Department. However, Brock claimed it was not her fault. She had tried to meet with both Whitmore and Wells more than once. She had left phone messages for them, but they always seemed too busy to meet, and were out of town on several occasions when she was available. So she decided she had better complete the report and distributed it on time to meet the deadline.

That same day, Whitmore and Wells discussed the problem over lunch. Wells was angry, too. He complained that Brock had bugged him to do the study, but her timing was bad. Wells was working on an important assembly area project of his own that was top priority to Whitmore. He couldn't take the time that Brock needed right now. He tried to tell her this before the study began, but Brock claimed she had no choice but to do the audit. Wells remembered, with some resentment, how Brock was unavailable last year when he needed her help. The staff audit group seemed to have plenty of time for the study when he couldn't give it any attention. Whitmore said he would look into the matter, and agreed that they both had been unnecessarily raked over the coals.

1. What were the causes and antecedents of the conflict between the staff audit group and the managers in the plant?

2. How can staff units work with line managers to minimize such conflict?

Other Engineering, Engineering

  • Category:- Other Engineering
  • Reference No.:- M91368555
  • Price:- $15

Priced at Now at $15, Verified Solution

Have any Question?


Related Questions in Other Engineering

Mine safety amp environmental engineeringpart 1 questions1

Mine Safety & Environmental Engineering Part 1. Questions 1. Occupational health and safety is the primary factor that needs to be considered in the mining industry. Discuss this statement. 2. Define the following terms ...

Homework - risk and decision management1 you are working

Homework - Risk and Decision Management 1) You are working program X. The total budget allocated to the program is $100 M and it is to be completed in 24 mo. range (R) and passenger capacity (C) are two key performance p ...

Assessment practical reportproduce a short technical report

Assessment: Practical Report Produce a short technical report in a form consistent with proteomic journals covering the techniques, results and interpretation of your proteomics experiment in the practical classes. The r ...

Load fault level analysis amp protection design of a remote

LOAD, FAULT LEVEL ANALYSIS & PROTECTION DESIGN OF A REMOTE AREA MICROGRID Assignment Please undertake the following analyses: 1. Calculate the 3-phase fault levels on Bus 2, Bus 3 and Bus 4 with the main supply connected ...

Task 1using the lab kit design a circuit for the processor

Task 1: Using the lab kit, design a circuit for the processor to control the output of a connected 7-segment LED display device. You will be provided with a standard common anode 7-segment display of the type FND-507 (or ...

Control theory - lab reportsfor experiments 1 to 4 you must

Control Theory - Lab Reports For experiments 1 to 4 you must undertake the following: a) At the start of each section (including the pre-lab activities) there are a number learning outcomes. That is, what students should ...

Register design a cpu register is simply a row of

Register design A CPU register is simply a row of flip-flops (i.e. SR, JK, T, etc) put side by side in an array to make the size of register required. For example, an 8 bit register has 8 flip-flops side by side for stor ...

Engineering analysis homework -for every problem provide

Engineering Analysis Homework - For every problem, provide The MATLAB script/function files that solve the problems. Problem 1: Write a script that solves the problem. For (c), show results of the evaluation of every ind ...

Assignment 11 what is the purpose of ore reserve and

ASSIGNMENT 1 1. What is the purpose of ore reserve and resource estimation? Why are resource and reserve estimates important to the mining industry? 2. What is meant by ore? What is meant by the term waste? How is the di ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Why might a bank avoid the use of interest rate swaps even

Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate

Describe the difference between zero coupon bonds and

Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p

Compute the present value of an annuity of 880 per year

Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As

Compute the present value of an 1150 payment made in ten

Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int

Compute the present value of an annuity of 699 per year

Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As