Assignment Title: Die Press Assembly Drawing
The objective of this assignment is to demonstrate the following concepts of design.
• Extrude
• Revolve
• Fillet
• Dimensioning
• Tolerance
• Basic shaping processes
• Basic joining processes
• Basic modeling and sketching techniques
Tasks that need to be done:
1. Report
Write a report about the concepts of mechanics in Section 1(a) of report. Your report should include a brief introduction and summary, as well as a list of references. Marks will be allocated for proper formatting, including these elements:-
- Report must have introduction, section headers and summary
- Pages of the report must be properly numbered
- Report must include a table of contents
- All figures and tables must be properly labeled and referenced in the text
- Properly citing sources of information using the Harvard Name System of Referencing
- Report should be written in about 2500 words [8 marks]
(a) Explain the concepts of design listed below and describe it in the form of a statement.
• Extrude
• Revolve
• Fillet
• Dimensioning
• Tolerance
• Basic shaping processes
• Basic joining processes
• Basic modeling and sketching techniques [32 marks]
(b) Perform a simple practical work in laboratory on design software which helps you to demonstrate the algorithm for Die Press Assembly Drawing as shown below.
(i) Write the algorithm for the drawing. [10 marks]
(ii) Draw 2D drawing with proper dimensioning. [5 marks]
(iii) Draw 3D drawing with proper dimensioning. [5 marks]
(iv) Assembly drawing with proper dimensioning. [10 marks]
Die Press Assembly Drawing
Note: - All dimensions are in mm
2. Demonstration
Describe and demonstrate the experiment which you have performed in front of your class. [30 marks]
Note: Student has to submit hard copy & soft copy of report in the form of CD also.