Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Other Engineering Expert

problem 1) A suspended ceiling in T.W/G.I, is to be provided for the office of size 4.0 m x 3.0 m, with a clear height of 3.0 m. Draw reflected ceiling plan and section to the scale of 1 : 20. And draw any three enlarged details to the scale of 1 : 5.

problem 2) Sketch plan and section showing reinforcement details of the straight flight stringer beam staircase of 3.0 m width and floor height 2.10 m to the scale 1 : 20. Also draw railing fixing details and tile fixing details to finish the tread and riser to a suitable scale.

problem 3) Describe with neat sketches:

a) Stub column & stanchion fixing.

b) Types of pile foundations, any three.

c) Reinforced brick work.

d) Types of lifts.

e) Bay window and its advantages.

f) Any two roofing systems developed by C.B.R.I.

problem 4) prepare brief notes with neat sketches:

i) Raft foundation.

ii) Method of polishing new wood-work.

iii) Guniting and its uses.

iv) Stainless steel and its uses in the building industry.

v) Terminology of retaining wall.

vi) Types of glass & its uses.

problem 5) Describe the difference between:

i) Dense concrete and light weight concrete.

ii) R.C.C. balcony and Canopy.

iii) Spine beam and castellated beam.

iv) Cohesive soil and non-cohesive soil.

v) Methods of water-proofing and damp proofing.

vi) Painting of wood and painting of steel.

Other Engineering, Engineering

  • Category:- Other Engineering
  • Reference No.:- M95381

Have any Question? 


Related Questions in Other Engineering

Problem 1a router is used to cut locating notches on a

Problem 1 A router is used to cut locating notches on a printer circuit board. The vibration level at the surface of the board as it is cut, is considered to be a major source of dimensional variation (lower the better) ...

Risk factors and gantt chartsquestion 1 project risk

Risk Factors and Gantt Charts Question 1: Project Risk factors • List the major risk factors for your project and the possible ways to mitigate this risks for your project. Question 2: Resource Evaluation • Produce and c ...

Introduction to signal analysis project music

Introduction to Signal Analysis Project: Music Synthesis Project Definition: The objective of this project is to synthesize musical signals. You will generate harmonic tones and use them to perform well-known melodies. M ...

Assignmentsuppose a large aerospace engineering firm has

Assignment Suppose a large aerospace engineering firm has immediately hired you as a consultant to investigate a potential violation of corporate policy and data theft. You have been informed that an employee may have be ...

Question 1 the two basic kinds of transistor circuits are

Question 1 The two basic kinds of transistor circuits are amplifying and switching. True False Question 2 The bridge rectifier is similar to a full-wave rectifier because it produces a full-wave output voltage. True Fals ...

Assignmentpart 1bullop-amp introduction1read chapters 1-2

Assignment Part 1 • Op-Amp Introduction 1. Read Chapters 1-2 in the text Op Amps for Everyone Fourth Edition 2. For the configuration below: 3. o With Vin = 4Vrms, f = 1kHz answer the following for each case: o Calculate ...

Problem 1nbspnbspnbspa letnbsphand calculate ab a-b ab ba

Problem 1:    (a) Let  Hand calculate A+B, A-B, AB, BA, CA, CB, and AC T . (b) Use MATLAB to verify your calculations. Problem 2: (a) Let Hand calculate |A|, r A , and A -1 if it exists. (b) Hand calculates the eigenvalu ...

The united states east to west water diversion

The United States East to West Water Diversion Project Background I was recently contacted by a concerned citizen in Naperville, Illinois with the following request: Dear Dr. Adam, I have written up an idea I've been thi ...

Homework consider a renewal process let x be the

Homework Consider a renewal process. Let X be the interrenewal times; and let I and R be the length of an interval interrupted at random and its remainder, respectively. The following BASIC simulation calculates the aver ...

System administration assignment-aim the aim of this

System Administration Assignment- Aim: The aim of this assignment is to become familiar with subnet masking and designing small networks for fictitious organizations. Task: Imagine you work for a firm which provides syst ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen