Ask Question, Ask an Expert

+61-413 786 465

info@mywordsolution.com

Ask Other Engineering Expert

1. You want to buy a house and take out a mortgage for $250,000. The only mortgage that you can afford is a 30 year ARM that has a fixed rate of 3% annual compounded monthly for the first 3 years and then can adjust every year after that. Against the advice of a wise EMIS professor that you once had, you decided to take the mortgage.

a) What is the monthly payment for his home mortgage for the first 3 years?

After you make the 36th payment, the interest rate adjusts to 5% annual compounded monthly.

b) What is the new monthly payment?

After you make the next 12 payments, the interest rate increases to 7% annual compounded monthly.
c) What is the new monthly payment?

You make the next 12 payments and the interest rate is about to adjust again. You decide that your old EMIS professor was right all along and you take out a new loan with a fixed interest rate of 4.5% annual compounded monthly for a term of 20 years.
d) What is the total amount of interest that you will pay for all of the mortgages (ARM plus fixed rate loans)?

2. You are looking to purchase a new vehicle for $24,500. This vehicle gets 21 mpg and you average driving 15,000 miles per year. You expect that gasoline will average $2.40 per gallon for the first year and will increase 15% per year but it will never get above $5 per gallon because of government controls. Maintenance is included for the first two years but after that you think that maintenance will cost $1,000 and increase by 10% per year after that. The vehicle will lose 30% of its value the first year but the salvage value will only decrease by 10% per year after that. For an interest rate of 6%, what is the economic life of the vehicle?

Other Engineering, Engineering

  • Category:- Other Engineering
  • Reference No.:- M92819352
  • Price:- $45

Priced at Now at $45, Verified Solution

Have any Question?


Related Questions in Other Engineering

Mine safety amp environmental engineeringpart 1 questions1

Mine Safety & Environmental Engineering Part 1. Questions 1. Occupational health and safety is the primary factor that needs to be considered in the mining industry. Discuss this statement. 2. Define the following terms ...

Load fault level analysis amp protection design of a remote

LOAD, FAULT LEVEL ANALYSIS & PROTECTION DESIGN OF A REMOTE AREA MICROGRID Assignment Please undertake the following analyses: 1. Calculate the 3-phase fault levels on Bus 2, Bus 3 and Bus 4 with the main supply connected ...

Assessment practical reportproduce a short technical report

Assessment: Practical Report Produce a short technical report in a form consistent with proteomic journals covering the techniques, results and interpretation of your proteomics experiment in the practical classes. The r ...

Q 1a discontinuity is found fully developed from the toe to

Q. 1 A discontinuity is found fully developed from the toe to the bench surface on a 15 m high slope, slope angle 65°. The discontinuity (frictional angle 32° and cohesion 20 kN/m2) is planar and its strike is parallel t ...

Task 1using the lab kit design a circuit for the processor

Task 1: Using the lab kit, design a circuit for the processor to control the output of a connected 7-segment LED display device. You will be provided with a standard common anode 7-segment display of the type FND-507 (or ...

A detailed review of spatial modulation and simulation

A Detailed Review of Spatial Modulation and Simulation Learning Outcomes a. Learn how to model mobile communication channels d. Discern knowledge development and directions on the recent advances in 4G to the research pr ...

Projection of planes1 a regular pentagon of 25 mm side has

Projection of Planes 1. A regular pentagon of 25 mm side has one side on the ground. Its plane is inclined at 45° to H.P. and perpendicular to the V.P. Draw its projections. 2. Draw the projection of a circle of 50 mm di ...

Engineering materials term paper assignment -conduct a

ENGINEERING MATERIALS TERM PAPER ASSIGNMENT - Conduct a thorough literature search and write a 15-20 page technical review paper on the evolution of the engineering materials used in the manufacturing of any one of the f ...

Control theory - lab reportsfor experiments 1 to 4 you must

Control Theory - Lab Reports For experiments 1 to 4 you must undertake the following: a) At the start of each section (including the pre-lab activities) there are a number learning outcomes. That is, what students should ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Why might a bank avoid the use of interest rate swaps even

Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate

Describe the difference between zero coupon bonds and

Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p

Compute the present value of an annuity of 880 per year

Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As

Compute the present value of an 1150 payment made in ten

Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int

Compute the present value of an annuity of 699 per year

Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As