Ethics in Engineering

Introduction - A production line engineer, Shane, checks every chip for quality control. His workers find errors approximately every 150 chips. Either the defective chips must be sent back for repair or they must be axed (thrown away). The manager, Rob, has mandated that workers must axe all defective chips. Rob walks over to Shane's line and declares, "Why some lines sink more dollars into a chip that failed, I don’t understand. We only make 25 cents off of each chip anyway! Spending an additional $2.00 per chip will only be more money down the drain. Shane, in our line of work we can’t afford to flush money down the toilet."

The following afternoon, Rob calls a meeting in his office. Rob informs Shane, that Shane's line is axing to many chips. "One chip every hundred and fifty is unacceptable! This is becoming a substantial cost to the company. I believe that it would be more beneficial be more beneficial to allow defective chips to go out the door." Shane asks, "What about the defective chips? Won't customers complain?" Rob replies, "Yeah, yeah, but that not your problem, the company has a return department that will replace them as customers complain." Rob further estimates that allowing defective chips on the market will yield a $416,000 profit for the company.

Facts

The line produces 100,000 chips per year, every chip is purchased, chips cost about $9.00 to produce, chip testing costs about $4.00 per chip, chip repair (manpower and material) is about $2.00 per chip, this repair cost includes re-testing, profit eper chip is $0.25 after testing, there are fifteen full-time employees working under Shane, two part-time employees work under Shane's supervision

Shane's manger, Rob, has been with the company for about 7 years, Shane has been working under the same manager for several years and has had relatively good relations with Rob.

Addition information regarding the Shane's line:

The engineer's line consists of the final inspection between the bond wires, which attach the chips to the prongs and spot plots (the prongs that protrude from the final product), just before the chips are encased in molding compound for final packaging. You may assume that all defects are caused by faulty bond wire attachment and not by any problem with the chip itself; because the chips are tested in the preceding phase before the bond wires were attached.

Questions on Ethics and Professionalism

1. What issues are involved in following Rob's recommendation?

2. Is it acceptable to follow Rob's suggested course of action?

3. If Shane has a differing opinion, how could he present his case to Rob?

Please give a detailed explanation for each part and utilizing numbers where they may apply.