1: If a cord on an appliance is damaged, wear rubber gloves and it is safe to continue use.
a) True
b) False
2: Work permit is the authorizing of a group or person to perform work in a plant.
a) True
b) False
3: Employees who are being proactive about safety, should try to identify potential hazards before the task could cause any harm.
a) True
b) False
4: Pedestrian should always look both sides of the road when crossing.
a) True
b) False
5: In case of any gas release in the plant, all employees should check where there is a gas leak and then proceed to the closest assembly point.
a) True
b) False
6: In the event of an emergency in a plant, you should run fast and go outside the plant.
a) True
b) False
7: It is not important to have a gas test done by a competent person before entering a confined space.
a) True
b) False
8: No person, other than certified plant operators, are allowed to operate plant equipment.
a) True
b) False
9: All Petro-Chemical plants always have four types of emergency alarms.
a) True
b) False
10: After all clear alarm in the plant, proceed to work area and start your work.
a) True
b) False
11: You are only responsible for your own safety at all times.
a) True
b) False
For the next part tick ONE answer only (4 points for each question)
12: Any liquid spill on the floor can cause an accident always clean it up.
a) when you have a time
b) at the end of job
c) immediately
d) all of above
13: Before you touch an electrical plug
a) your hand should be dry
b) ask your supervisor
c) your hand must be clean
d) all of above
14: To be able to put out a fire safely you should know
a) how to use extinguisher
b) how to use a fire blanket
c) where the extinguisher is located
d) all of above
15: Make sure equipment & tools are kept clean
a) Before you use it
b) After you use it
c) All of the above
16: What is classed at work at height?
a) Work above 4 feet
b) Work above 1 meter
c) Work above 6 feet
d) All of above
17: How many different classes of fire is there?
a) A,B,C,D
b) A,E,C
c) A,B,C,D,E
d) All of above
18: What are the Hazards in a confined space?
a) Deficiency of oxygen
b) Toxic or flammable gases
c) Limited means of access and egress
d) All of above
19: Who can place and sign a scaffolding tag
a) Site manager
b) Safety officer
c) Competent person
d) All of above
20: What is a MSDS?
a) Material safety data sheet
b) Mechanical safety data sheet
c) Mandatory safety data sheet
d) All of above
21: Who can receive the work permit?
a) Site supervisor
b) Site safety officer
c) Permit receiver
d) All of the above
22: Keep the work area clean and free from hazard by doing housekeeping.
a) Constantly
b) Once a week
c) Before and end of shift
d) All of above
23: Good housekeeping will minimize the hazards.
a) Slips ,trips and falls
b) Fire
c) Personal hygiene
d) All of above
24: What is the most common cause of accident?
a) Personal behavior
b) Leave a box lying on the floor
c) Throwing spanner from height
d) All of the above
25: What is the main type of injury of manual handling?
a) Back injuries
b) Hand injuries
c) Arms shoulder and leg injuries
d) All of above